I am working with a friend on a project. Replacing front motor mount on 1997 Electraglide. Does anyone know if the torque settings would be the same as my 2008 Roadking? I have the service manual for the Roadking but not the Electraglide. I have looked in the self help section but have not found any specific settings.
1997 Electraglide motor mounts
- Thread starter DCLARKE
- Start date
I have a 97 Electra Glide Classic. In my service manual it says,
"Tighten primary housing-to-engine mounting bolts to 16-18 ft-lbs (22-24Nm) torque. Tighten rear engine mounting bolts to 35-38 ft-lbs (47-52 Nm) torque.
I hope that helps.
DCLARKE
You might want to double check what I quoted you. The service manual came with my bike, but I am not a mechanic!
Good luck.
"Tighten primary housing-to-engine mounting bolts to 16-18 ft-lbs (22-24Nm) torque. Tighten rear engine mounting bolts to 35-38 ft-lbs (47-52 Nm) torque.
I hope that helps.
DCLARKE
You might want to double check what I quoted you. The service manual came with my bike, but I am not a mechanic!
Good luck.
Last edited by a moderator: