2004 Dyna vibration

[edmis10]

I have recently replaced leaking seals on my 2004 Dyna low rider. I, at the same time changed the lube to HD Syn3 in all three holes. Since reassembly, I have noticed a vibration in all gears at around 2000 rpm. It runs smooth when cold, but begins to vibrate after about 30 min of riding. When I first noticed it, I suspected that I had missed something during reassembly, so I took it back down and did it again. Still there. I had also remapped the Commander III EFI to match the bikes exaust and air. The original map was for stock and I am running Python full exhaust and Screaming Eagle air. Temporarily put the old map back in. Still there. Looking for ideas.

 

[HDDon]

What were you running for lube in your trans and engine oil? I would not recommend syn3 in all areas.

 

[edmis10]

I don't know what the previous owner had in the bike. I presume gear lube in the chaincase and HD lube in the engine and tranny. What do you recommend?

 

[Spade5]

I personally think HD Formula+ is fine in the primary and transmission. There may be better after market choices but I'm not going there.

Even though HD said Syn3 in all three holes for some models, I think they backed off of that.

I am sure others will give you some suggestions.

 

[edmis10]

From what I have read recently, I think that your advice is sound.. I'm going to change the chaincase and tranny lube asap. Thanks

 

[wilks3]

I use;
Engine/Lucas Synthetic 50wt
Trans/Redline Synthetic Heavy Shockproof 75W140
Primary/Mobile1 4t 10W40, OK for wet clutch's
wilks3
:USA