jigglestick
Member
I have read numerous posts regarding check engine light and retrieving diagnostic codes. I am assuming that I have a stored code in my 2003 Road king Classic EFI.
Turning my switches on I get the following:
Light on 4 sec
Light off 6 sec
Light on 8 sec
Light off, stays off.
That happens whether the bike is running or not.
I followed the instructions to attempt to pull a code. I used a female 14 ga spade connector to jump terminals 1 & 2. No change in light sequence. Same as above.
Thoughts?
Turning my switches on I get the following:
Light on 4 sec
Light off 6 sec
Light on 8 sec
Light off, stays off.
That happens whether the bike is running or not.
I followed the instructions to attempt to pull a code. I used a female 14 ga spade connector to jump terminals 1 & 2. No change in light sequence. Same as above.
Thoughts?