turn signals

[superglyde]

I removed my front signals. now my rear left works and right does not.any body got a fix for this

 

[Hoople]

My guess would be the system needs some load resistors to balance out the circuit. The TSM needs to think the front bulbs are still installed.

 

[glider]

I agree with Hoop. The TSM/TSSM is designed to work with a certain load and if you change the load, it will not operate properly.

 

[R_W_B]

One way to tell for sure is just pop the wires out the bottom and hook the front sigs up temp real quick. If everything works then Hoop and Glider nailed it and you need to either keep your front sigs or hunt down a load equalizer.

By the way guys where does one buy these things. Do they generate heat the way the run/turn modules do ?

I've read that you should not leave your flashers on too long with a run/turn module installed since they can overheat and fail.

 

[sprinklerfitter669]

How about a loose wire when you put them back on ?

 

[R_W_B]

How about a loose wire when you put them back on ?

A loose wire is always possible but if I read his post correctly he did not remove his rear ones only the front. The rear ones connect under the seat, the front ones connect under the frame neck.