kemo R.I.P Jun 26, 2009 #1 I was reading an article on adj p/r. It said to measure the threads per inch and multiply by .6. My S/E p/r's are 24 tpi. X.6 = 14.4 flats. The recommended adj is 2 1/2 turns. Seems to me 14.4 would be tight. What do you think Glider
I was reading an article on adj p/r. It said to measure the threads per inch and multiply by .6. My S/E p/r's are 24 tpi. X.6 = 14.4 flats. The recommended adj is 2 1/2 turns. Seems to me 14.4 would be tight. What do you think Glider
G glider Veteran Member Jun 26, 2009 #2 You have to follow the manufacturers recommendations because of the threads per inch for their rods. When you don't that's where the problems start.
You have to follow the manufacturers recommendations because of the threads per inch for their rods. When you don't that's where the problems start.
